<div class="csl-bib-body">
<div class="csl-entry">Holub, E., Ramer, G., Lendl, B., & Hondl, N. (2023, April 13). <i>Photothermal heterodyne imaging in air and aqueous media – parameters and perspectives</i> [Poster Presentation]. ANAKON 2023, Wien, Austria.</div>
</div>
-
dc.identifier.uri
http://hdl.handle.net/20.500.12708/191703
-
dc.description
Based on a commercial confocal microscope, a mid-IR (MIR) photothermal spectroscopy (PTS) instrument was developed at TU Wien to better understand the mechanisms governing photothermal image quality. Photothermal spectra and images of polystyrene beads were presented.
-
dc.description.abstract
Introduction
First described by Berciaud et al. [2] [3] for imaging of metallic and crystal nanoparticles, the photothermal (PT) heterodyne technique combines biological specificity and sub-micron resolution. Albeit it has been explored in a myriad of applications [1], data on imaging in water are rather scarce.
A dedicated PT testbed was implemented at TU Wien. System parameters were carefully modified to better understand the mechanisms governing PT image quality. Design choices and parameters for PT imaging will be explained and supported by theoretical evidence.
Methods
The presented testbed is based on an existing confocal microscope at TU Wien. Simulations were carried out to optimise the setup for broadband IR laser sources and a transmission geometry. The confocal microscope was modified to incorporate a second objective for bottom illumination with an IR laser (pump laser). The samples were probed with a HeNe laser (633 nm), and the transmitted PT signal was collected by an off-the-shelf amplified photodiode and recovered from the modulation of the visible beam using a lock-in amplifier. PT spectra and images of polystyrene beads of various sizes were recorded in both air and water. The imaging parameters and observed artifacts were checked for consistency with theoretical expectations.
Results
PT imaging of 1 µm beads has revealed an optical resolution of 1.5 µm, which is well below the diffraction limit of the 6 µm IR beam. The calculated signal-to-noise ratio (SNR) ranged from 5 to almost 80 depending on the parameters and the environment of the experiment.
The SNR critically depends on the choice of imaging parameters, which can be found by theoretical considerations. The presence of fringes in PT imaging has been attributed to the object of interest being off-centre of the confocal laser spot.
Measurements in water have been demonstrated but remain challenging. Further optimisation will be required to improve SNR and avoid damage to sensitive samples.
Innovative aspects
• Innovative setup based on existing confocal instrument
• Theoretical background of imaging parameters and artifacts
• Photothermal imaging in water
Acknowledgements
This project has received funding from the European Union’s Horizon 2020 research and innovation programme within the project “Tumor-LN-oC” under grant agreement no. 953234.
References
[1] Adhikari, S. et al., Photothermal Microscopy: Imaging the Optical Absorption of Single Nanoparticles and Single Molecules”. ACS Nano 2020, 14, 6414–6445.
[2] Berciaud, S. et al., Photothermal Heterodyne Imaging of Individual Nonfluorescent Nanoclusters and Nanocrystals. Physical Review Letters 2004, 93, 257402.
[3] Berciaud, S. et al., Photothermal heterodyne imaging of individual metallic nanoparticles: Theory versus experiment. Physical Review B 2006, 73 (4), 045424.
en
dc.description.sponsorship
European Commission
-
dc.language.iso
en
-
dc.subject
Photothermal Spectroscopy
en
dc.subject
photothermal imaging
en
dc.subject
image quality
en
dc.title
Photothermal heterodyne imaging in air and aqueous media – parameters and perspectives
en
dc.type
Presentation
en
dc.type
Vortrag
de
dc.relation.grantno
953234
-
dc.rights.holder
Elisabeth Holub
-
dc.type.category
Poster Presentation
-
tuw.project.title
Tumor und Lymphknoten auf einer Chip Plattform für Krebsstudien
-
tuw.researchTopic.id
C6
-
tuw.researchTopic.id
I8
-
tuw.researchTopic.name
Modeling and Simulation
-
tuw.researchTopic.name
Sensor Systems
-
tuw.researchTopic.value
25
-
tuw.researchTopic.value
75
-
tuw.publication.orgunit
E164 - Institut für Chemische Technologien und Analytik
-
tuw.publication.orgunit
E164-02-1 - Forschungsgruppe Prozessanalytik
-
tuw.author.orcid
0000-0001-8307-5435
-
tuw.author.orcid
0000-0003-3838-5842
-
tuw.author.orcid
0009-0001-9282-4474
-
tuw.event.name
ANAKON 2023
-
tuw.event.startdate
11-04-2023
-
tuw.event.enddate
14-04-2023
-
tuw.event.online
On Site
-
tuw.event.type
Event for scientific audience
-
tuw.event.place
Wien
-
tuw.event.country
AT
-
tuw.event.institution
TU Wien
-
tuw.event.presenter
Holub, Elisabeth
-
wb.sciencebranch
Chemie
-
wb.sciencebranch
Physik, Astronomie
-
wb.sciencebranch.oefos
1040
-
wb.sciencebranch.oefos
1030
-
wb.sciencebranch.value
70
-
wb.sciencebranch.value
30
-
item.languageiso639-1
en
-
item.openairetype
conference poster not in proceedings
-
item.grantfulltext
restricted
-
item.fulltext
no Fulltext
-
item.cerifentitytype
Publications
-
item.openairecristype
http://purl.org/coar/resource_type/c_18co
-
crisitem.author.dept
E164-02-1 - Forschungsgruppe Prozessanalytik
-
crisitem.author.dept
E164-02-1 - Forschungsgruppe Prozessanalytik
-
crisitem.author.dept
E164-02 - Forschungsbereich Umwelt-, Prozessanalytik und Sensoren
-
crisitem.author.dept
E164-02-1 - Forschungsgruppe Prozessanalytik
-
crisitem.author.orcid
0009-0006-0703-9524
-
crisitem.author.orcid
0000-0001-8307-5435
-
crisitem.author.orcid
0000-0003-3838-5842
-
crisitem.author.orcid
0009-0001-9282-4474
-
crisitem.author.parentorg
E164-02 - Forschungsbereich Umwelt-, Prozessanalytik und Sensoren
-
crisitem.author.parentorg
E164-02 - Forschungsbereich Umwelt-, Prozessanalytik und Sensoren
-
crisitem.author.parentorg
E164 - Institut für Chemische Technologien und Analytik
-
crisitem.author.parentorg
E164-02 - Forschungsbereich Umwelt-, Prozessanalytik und Sensoren
