Tirler, S. (2026). Modelling the growth of the algae Chlorella Vulgaris and Spirulina in an airlift pump bioreactor [Diploma Thesis, Technische Universität Wien]. reposiTUm. https://doi.org/10.34726/hss.2026.140413
quasi-one-dimensional modelling; multiphase mass transfer
en
Abstract:
In the course of this thesis, the growth of the algae Chlorella Vulgaris and Spirulinais modeled in an airlift pump bioreactor and simulated using Matlab. The algae is part of a water suspension that is pumped through a system of vertical glass tubes. At the bottom of the piping, CO2 is added continuously through gas bubbles. The bioreactor acts as a co-current and counter-current mass exchanger where CO2 diffuses from air bubbles into water, and further into the algae, aiding its growth. Seven models for the CO2-transfer through the relevant surfaces are compared to each other and the influence of different parameters is evaluated. From the seven models, four are finally taken into account for C. Vulgaris. For Spirulina it could be concluded, that the seven present models are not able to properly take into account its elongated shape. The focus was on setups with no initial, additional CO2-enrichment of tap water in Lower Austria as the suspension fluid, a gas bubble supply with 5% CO2 and an initial algae content of 0.1 g per liter suspension fluid at the beginning of each tubing system round flow. 32 of the single bioreactors, running in parallel, each with a total tubing length of 8 km, are simulated. C. Vulgaris is typically cultivated during the winter season, whereas Spirulina iscultivated during the summer season. From an initial wet mass infusion of Chlorella Vulgaris of 0.1 g/l, which is a factory total algae input of 1.06 kg per hour, a C. Vulgaris yield mass flow up to 3.84 kg/h can be achieved as part of approximately 11,000 liter suspension passing the reactors each hour. This is accompanied by a CO2 consumption in the range of up to 15.41 kg/h, as well as an O2 production up to 11.20 kg/h. At the beginning of the winter harvesting season 18.25 kg C. Vulgaris are required. Depending on the underlying model, between 42.9 t and 47.2 t of C. Vulgaris biomass can be harvested over the six-month period. After drying, this results in between 8.6 t and 9.4 t of algae powder, from which 3.1 t to 3.5 t of C. Vulgaris oil can be extracted. For Spirulina, none of the considered models seems to realistically models its growth. However, the models that were identified as the most realistic for C. Vulgaris and additional one that gives at least 50% of the expected results are considered in the final evaluation. Assuming the same input masses, the yield mass flow rates are assessed. As part of an hourly flow of 11,000 liter suspension passing the reactors, again depending on the underlying model, up to 14.45 kg/h algae is produced. The CO2 use-up rate is simulated with up to 4.46 kg/h, the O2 production up to 3.24 kg/h. Over the course of the six months summer harvesting season, again from an initial total infusion of 18.25 kg, this results in up to 26.0 t biomass. After drying, this would result in up to 5.5 t algae powder. From this 1.9 t algae oil could be pressed.
en
Additional information:
Arbeit an der Bibliothek noch nicht eingelangt - Daten nicht geprüft Abweichender Titel nach Übersetzung der Verfasserin/des Verfassers